Welcome to the DMR Site for British Car Information.
|
|
MG MGA - Good intentions
| Sorry for being dim but I thought I would finish of the service today. Oil the water pump, the manual says. Mine looks like it's sealed. Lubricate the dynamo bearing. Mine has a plastic cap at the back that doesnt seem to come off easily & I dont really want to force it in case it's not supposed to come off. Grease the universal joints. Guess what? No grease nipples - just one on the sliding joint. Am I blind, or are all these bits normally sealed these days? Thanks |
| Graham M V |
| The newer water pumps are sealed as are the universal joints on the prop shaft. It's a good idea to shoot a little oil at the rear end of the dynamo; don't over-tighten the fan-belt as that will likely cause the bearings in the dyno. to go. |
| David Werblow |
This thread was discussed on 21/05/2011
MG MGA index
This thread is from the archives. Join this live forum now