Welcome to the DMR Site for British Car Information.
|
|
MG Midget and Sprite Technical - When shocks go bad!
| Look what my mechanic discovered! I really should examine my car more often and more thoroughly (doh!). What would cause this? The shocks are less than 6 months old (reconditioned).
|
| gusangora |
| Waht would cause this? Not uncommon on this kind of suspension but safe to say that poor reconditioning is a factor. |
| Robert (Bob) Midget Turbo |
| Most recon shocks are rubbish (moss mgoc etc) that is why the FL kit is so attractive (though not without faults) Generaly you get what you pay for.... Cheap rebuilds = rubish Expensive shocks = posible good work (can still be rubbish though) Afaik Peter May has good ones as does Peter Caldwell in the US non that I know on your continent |
| Onno Könemann |
| Tell him to pop it back in with a spot of superglue on the shaft. A |
| Anthony Cutler |
| Is that pivot pin bent? Looks like it's been protruding a while, given the visible rusty surface buildup. I just had the same failure (@~15 K miles).. Installed the Caldwell units, they shipped quick and took the knackered unit as core. Getting them shipped Down Under might be a bit $$, but maybe less expensive than swapping them out every 6 months? FWIW: Mine developed an annoying squeak where the lever arm protrusion meant for the bump stop instead rubbed against the bump stop during normal up/down travel. Wouldn't squeak at all while braking or in a turn. Did yours do similar? I should feel lucky I got ~15 K miles from mine. Yours didn't even have the decency to stick around long enough to build up a respectable patina of Standard British Lubrication.
|
| Richard Reeves |
| Mine did not squeak at all. I heard a "clunk" on about 3 occasions since fitting (ie last 5 months) and I drive mine every day. I have asked the mechanic to investigate the cause and will report back. No point installing a replacement if it's going to happen again. |
| gusangora |
This thread was discussed on 06/06/2011
MG Midget and Sprite Technical index
This thread is from the archives. Join this live forum now