Welcome to the DMR Site for British Car Information.
|
|
Austin-Healey Sprite - Hot Starting Problem
| At my wits end after 14 month Sprite re-build. Would welcome any ideas. We have completed a full nut & bolt re-build. Engine has been bored out to +40 thou. New pistons, rings etc. MG Metro Turbo Head. Fast road cam. HS4 su's. Starts, runs and drives fine. Oil pressure & temp fine. Then the problems start. Once at normal temperature if your turn the engine off & then try to restart the starter will just about turn it over - like a slow cough - not fat enough to blow the skin off a rice pudding. Couple of goes and the starter just clicks. Starter is re-con. Have taken it off and had it checked. All is fine. Tried different batteries which are known to be good & fully charged. Once it's gone stone cold again it turns over & starts fine & runs till you turn it off. Stumped. Any ideas anyone? Rob |
| R J Harris |
| Make sure the earth cable from battery to bodyshell is in excellent condition and earthed via the flat steel surface with no paint but a little vaseline on it,it will not earth satifactorilly if you rely on the screw threads. Same with the power cable to the starter make sure it has good connections. |
| AP Jones |
This thread was discussed between 22/06/2011 and 23/06/2011
Austin-Healey Sprite index
This thread is from the archives. Join this live forum now